All previous halogen refrigerants had contained chlorine (CFC's and HCFC's), and that is the most easily detected component using Corona Discharge Technology. Clean Air Act led to the introduction world-wide of chlorine-free refrigerants (HFC's) and an immediate rush by detector manufacturers to produce a tool able to respond, at appropriate levels, to a gas with no chlorine content. The growing concern over ozone-depletion, the Montreal Protocol and the U.S. Ion-pumping, or electron-wind, is a phenomenon readily demonstrable in a laboratory at 50 or 100,000 volts but is negligible to nonexistent at the voltages used in electronic leak detectors. This mechanical pump is far superior to any so-called ion-pump method. This gives appreciably quicker response time than a system which relies only on diffusion for a gas leak to penetrate the tip, and very much quicker clearing time, allowing the user to move quickly to the next suspect leak point. This small motor-driven fan assembly, mounted in the probe handle, actively draws air into the sensing tip and vents it through the back of the handle. From a user point of view, one of the most significant of these features was the introduction of the "Micro-pump" probe assembly. Over the years this concept was refined and improved with extensive research into electrode metals, tip shell materials and finishing procedures as well as circuitry changes and features to improve response time and "clearing" time. The invention, in 1963, of the Corona Discharge Detection Method introduced the age of the electronic detector. HFC 134a), and the fact that in some locations an open flame is obviously dangerous. It is a reliable tool but has several disadvantages: small color changes, especially in bright sunlight, are very difficult to see large doses of chlorinated refrigerant can produce phosgene gas (COCI2), a poison the inability to detect non-chlorine based refrigerants (E.G. This tool uses an open flame to heat a small copper plate, and any halogen gas introduced causes a change in the flame color. In small capacity refrigeration or air conditioning systems, however, significant leaks of a few ounces a year could not be easily found with bubbles, and the "halide torch" was introduced. For substantial leaks this is still a very effective "detector" and is, in fact, the method most commonly used to this day in high pressure gas production such as compressed air, oxygen, nitrogen, etc. Electronic Halogen Leak Detector The Development of the Electronic Halogen Leak Detectorįor many years the most effective, and only, method for finding gas leaks of any type was the use of a soap or "bubble" solution.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |